6/4 D-AH Rubber Lined Horizontal Slurry Pumps are Ready to Morocco
Oct 26, 2020
Tobee® 6/4 D AH Centrifugal Slurry Pumps are ready for delivery, The total 3 sets of 6/4 slurry pumps will be used in phosphate ore.

6x4D-AH Rubber Lined Slurry Pump is similar to 6x4D-AH Metal Lined Slurry Pump in structure. The main difference between AH and AHR is the material of wet parts, which are natural rubber, synthetic rubber or other wear-resistant rubbers. The Rubber Lined Slurry Pumps are more suitable in delivering strong corrosive or abrasive slurries of small particle size without sharp edges.

Rubber is lighter and more flexible than other wear liner materials. This helps with installation as it is easier to lift and install quickly and efficiently; a positive outcome for the health and safety of workers on site.

Using rubber as a wear lining material means:

    ▪ Less downtime
    ▪ Longer intervals between maintenance
    ▪ Lower inventory
    ▪ Better safety

Rubber lining has been used for almost a century to protect plant and equipment from wear, and has retained its position as the preferred wear material for the pumping and separation of fine particle slurries.

Tobee® 6/4 Rubber Lined Slurry Pump with Gland Packing Photos:

6/4 DAH Warman Rubber Pump

6/4 D-AH Rubber Lined Warman Pumps

Equivalent Warman 6x4 AH Slurry Pump

Warman 4 inch Centrifugal Slurry Pumps

6x4DAH Slurry Pump with Rubber Lined

6x4 AH Slurry Pump with Packing Seal

Technical dept.
Hebei Tobee Pump Co.,Limited