Materials: Natural Rubber, Viton, Synthetic rubber Part code: 060, 132, 089, 217, 109 Pump model: AH(R), HH, L(R), G(H), SP(R), AF etc
Slurry Pump Intake Joint is used for sealing the pump with inlet pipeline or inlet valve for preventing leak from suction end, It is installed on slurry pump suction flange.
Slurry Pump Discharge Joint is used for sealing the pump with discharge pipeline or discharge valve for preventing leak from discharge end, It is installed on slurry pump discharge flange.
Slurry Pump O-ring is designed for sealing two or more slurry pump parts during assembly, it is a loop of elastomer with a round cross-section. The O rings mainly are Bearing sealing ring (code 089), Impeller O ring (code 217), Shaft O ring (code 109).
Slurry Pump Volute Seal is used for sealing volute liner with throatbush and frame plate liner insert, It is designed to prevent the liquids entering slurry pump chamber.
Slurry Pump Rubber Seals Positions:
Note:
* Tobee® is a registered trademark and does not represent or is not in any way affiliated with Warman® of Weir Minerals Group. All names, numbers, symbols and descriptions are used for reference purpose only and do not imply that any pumps or parts listed is the product of Warman Pumps.
* Tobee® slurry pump rubber seals are only interchangeable with Warman® slurry pump rubber seals.
* This document is the property of Tobee® Pump and can be neither reproduced nor disclosed to a third party without a written authorization.
HEBEI TOBEE PUMP CO., LIMITED
Tel: +86 180 3203 4573
Fax: +86 311 8722 1317
E-mail: [email protected]
Skype: Tobee.Pump
Add: No. 266, Tianshan St, High-tech Zone, Shijiazhuang City 050000, China.